- Equipment List
- Setting Up the Lab
- Pre-Lab Tasks
- General Guidelines
- Practice Lab 1
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
- Practice Lab 1: "Ask the Proctor"
- Section 1.1: Frame Relay Configuration
- Section 1.2: 3550 LAN Switch Configuration
- Section 1.3: ATM Configuration
- Section 2.1: RIP
- Section 2.2: EIGRP
- Section 2.3: Redistribution
- Section 3: ISDN
- Section 4: EGP Protocols
- Section 5: Voice
- Section 6: DLSw+
- Section 7: IOS and IP Features
- Section 8: QoS
- Section 9: Multicast
- Practice Lab 1 Debrief
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
Section 3: ISDN (8 Points)
Ensure that VLAN3 and R4 Lo0 are accessible from R1 and beyond should the Frame Relay network fail either physically or logically. If VLAN3 and R4 Lo0 networks are restored while the ISDN line is active, ensure that traffic is routed over the Frame Relay network to these destinations immediately.
Configure R1 so that if half of the ISDN traffic to R4 is of an unacceptable quality, the line is automatically disconnected.
Allow only R1 to dial into R4. Do not use any PPP feature in your solution.
Do not allow the ISDN to flap if the Frame Relay network goes up and down; only allow the line to be dropped if the Frame Relay connectivity is deemed to be reliable for 90 seconds.