- Equipment List
- Setting Up the Lab
- Pre-Lab Tasks
- General Guidelines
- Practice Lab 1
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
- Practice Lab 1: "Ask the Proctor"
- Section 1.1: Frame Relay Configuration
- Section 1.2: 3550 LAN Switch Configuration
- Section 1.3: ATM Configuration
- Section 2.1: RIP
- Section 2.2: EIGRP
- Section 2.3: Redistribution
- Section 3: ISDN
- Section 4: EGP Protocols
- Section 5: Voice
- Section 6: DLSw+
- Section 7: IOS and IP Features
- Section 8: QoS
- Section 9: Multicast
- Practice Lab 1 Debrief
- Section 1: Bridging and Switching (15 Points)
- Section 2: IP IGP Protocols (28 Points)
- Section 3: ISDN (8 Points)
- Section 4: EGP Protocols (17 Points)
- Section 5: Voice (6 Points)
- Section 6: DLSw+ (4 Points)
- Section 7: IOS and IP Features (10 Points)
- Section 8: QoS (8 Points)
- Section 9: Multicast (4 Points)
Section 7: IOS and IP Features (10 Points)
R2 is sited in a shared data center; make the serial link back into R1 as secure as possible at Layer 2.
Ensure traffic from VLAN4, including any attached router interfaces to VLAN4, is hidden behind R5 lo0 address when directed toward all external router networks.
A router is to be installed onto VLAN4 in the future. This router will have a default configuration, so allow R6 to assist dynamically to aid the configuration process. The router will require an IP address of 10.50.50.6 and should load a configuration file called R9-config from a fictitious TFTP server on 172.16.0.59.